-
basic_ofdm_inter
basic ofdm with interlever:
The
transmitter section converts digital data to be transmitted, into a mapping of
subcarrier amplitude and phase. It then transforms this spectral representation of
the data into the time domain using an Inverse Discrete Fourier Transform
(IDFT).
The Inverse Fast Fourier Transform (IFFT) performs the same operations as an
IDFT, except that it is much more computational efficiency, and there is used in
all practical systems. In order to transmit the OFDM signal the calculated time
domain signal is then mixed up to the required frequency.
- 2013-05-02 01:39:22下载
- 积分：1
-
PSO_MATLAB_toos
matlab的PSO工具箱，只需对参数和目标函数设定就可以进行粒子群计算(PSO toolbox matlab, simply set the parameters and the objective function can be particle swarm meter
)
- 2012-02-06 19:29:15下载
- 积分：1
-
Hertzian-dipole
高斯脉冲波源下的磁偶极子场的计算，并与fdtd法进行了比较(The analytical solution to the Hertzian Dipole (with a Gaussian pulse source) problem for comparison with the FDTD simulation.)
- 2014-02-24 22:35:17下载
- 积分：1
-
CAVERN
该程序是在flac下运行的，没找到flac，所以用matlab表示了，供岩土力学研究方向学习(The program is run under flac, did not find flac, so use matlab shows for rock mechanics research study)
- 2015-01-05 21:09:09下载
- 积分：1
-
3dPML
带有完美匹配层的三维FDTD仿真，用于电磁波和光学仿真()
- 2007-09-23 01:33:36下载
- 积分：1
-
sfun_mppt_po
光伏逆变系统的最大功率点跟踪算法，采用的是扰动观察方法，采用s函数编写，可直接载入simulink使用(maximum power point tracking method using perturb and observe method, written by s-function)
- 2012-11-13 02:02:41下载
- 积分：1
-
matlab123
很简单实用的一段边缘检测的matlab程序，请各位指正。(A very simple and practical procedures for edge detection matlab, please correct me.)
- 2011-05-15 12:25:27下载
- 积分：1
-
MutualInfo
可以实现离散和连续变量的互信息计算，可以实现离散和连续变量的互信息计算，可以实现离散和连续变量的互信息计算。(Can achieve continuous variables and discrete mutual information calculation can be realized mutual information continuous variables and discrete calculations may be implemented discrete and continuous variables calculated mutual information.)
- 2017-04-28 14:39:10下载
- 积分：1
-
zhixiangxing
直线阵自然指向性仿真,先根据设定的角频率仿真单频信号A sin(ωt)；再根据阵元间距、入射角度计算得各阵元相对参考阵元接收的信号的时延 τ (dsin(θ))/c。
假设等间隔N基元线阵，入射信号是平面波，那么阵元输出信号为：S_n (t) A sin(ωt+nφ)；其中 φ 2πfτ 为相邻阵元接收信号间的相位差；再将基阵各元输出求和，取最大值max,就得到输出幅度；以入射角为横坐标，幅度为纵坐标作图得直线阵自然指向性。
(Linear array directivity simulation)
- 2020-12-05 14:39:24下载
- 积分：1
-
linear-FM-chirp-signal-generate-
说明： 切普信号生成，可以改变信号的起始频率和最终频率。(Be able to generate a linear-FM “chirp” signal that sweeps in frequency fromω1 = 2pi*f1 to ω1 = 2pi*f2 as time goes from t = 0 to T2. You can change any of these values.)
- 2011-03-31 09:19:23下载
- 积分：1
