登录
首页 » matlab » codes

codes

于 2012-09-08 发布 文件大小:89KB
0 97
下载积分: 1 下载次数: 3

代码说明:

  i am uploading some matlab source codes

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • Electromagnetic_Data_Procession_Matlab
    大学时候跟导师做的一个暂态电磁场数据分析的程序,用于自动检测和识别波形数据中的脉冲起始时间等参数(University instructors often do with a transient electromagnetic field data analysis procedures, for the automatic detection and identification of waveform data pulse parameters, such as start-up time)
    2006-08-09 09:55:36下载
    积分:1
  • SimulationChart_ADRC
    自抗扰控制(ADRC)simulink框架图,包括跟踪微分器,非线性状态反馈,状态观测器(Active disturbance rejection control frame diagram)
    2021-03-27 09:39:12下载
    积分:1
  • xuanbiliang
    采用模态叠加法和Newmark方法求解悬臂梁的响应,可以直接运行,经验证程序正确(Modal superposition method and Newmark method for solving cantilever response, and can directly run the program properly validated)
    2020-12-21 15:59:09下载
    积分:1
  • move
    演示对称振子天线的立体方向图,此程序为动画效果的程序。(Demo three-dimensional symmetric dipole antenna pattern, the procedure for animation programs.)
    2011-05-23 11:41:27下载
    积分:1
  • AddNoise-PSNR
    对图像进行添加噪声处理,并计算相应的峰值信噪比的matlab程序。(A matlab program: add noise to an image and calculate correspondly the Peak Signal to Noise Ratio . )
    2012-05-13 17:20:21下载
    积分:1
  • mie-scattering
    米氏散射系数,在不同条件下,雨中,霜雾,晴朗天气(Mie scattering coefficient under different conditions, rain, frost and fog, sunny weather)
    2012-06-06 19:12:16下载
    积分:1
  • III_Year_Previous_Papers_JWFILES
    The principle of space time block coding with 2 transmit antenna and one receive antenna is explained in the post on Alamouti STBC. With two receive antenna’s the system can be modeled as shown in the figure below
    2013-03-21 00:50:57下载
    积分:1
  • ofdmmatlab
    很不错的ofdm仿真程序,改程序会使你对正交频分复用有较深的理解(OFDM is a good simulation program, changing the procedure would you OFDM has a better understanding of)
    2008-07-04 14:53:41下载
    积分:1
  • re1
    The model used for creating the reference voltage is shown in Fig. 4. First, photovoltaic output current (Ipv) and output voltage (Vpv) are passed through a first order low pass filter with a magnitude of G = 1 and a time constant of T = 0.01 seconds in order to filter out the high frequency components or harmonics from these signals as shown in Fig. 5 and Fig. 6. The filtered current and voltage signals (Ipv_F and Vpv_F) are then fed into the MPPT control block that uses the Incremental Conductance Tracking Algorithm. An algorithm that is based on the fact the slope of the PV array power curve shown in Fig. 7 is zero at the Maximum Power Point (MPP), positive on the left of the MPP, and negative on the right. The MPP can thus be tracked by comparing the instantaneous conductance (I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
    2013-07-23 17:51:25下载
    积分:1
  • cycloid-motion
    通过matlab绘制一个运动的图,图中为小球摆线运动(Matlab draw a sports figure, the figure for the cycloidal motion of the ball)
    2012-08-20 10:59:57下载
    积分:1
  • 696518资源总数
  • 104384会员总数
  • 26今日下载