-
yuanzhut
一杯沸水冷却，圆柱体模型，底面半径0.05m，高0.1m，周围温度20度，初始水温100度
方程是四维输运方程（常数a^2=k/(c*p)，k是热传导系数0.6006焦/（米*秒*度））
初始条件：t=0时水等于100度
边界条件：1.上下壁都是自由冷却，第三类边界条件，周围温度保持在20度（H=k/h,h取1）
2.杯壁绝热，第二类边界条件
(cup of boiling water cooling cylinder model, the bottom radius of 0.05m, 0.1m high. temperature around 20 degrees, initial temperature of 100 degrees equation is four-dimensional equations (a constant ^ 2 = k/(c* p), k is the thermal conductivity coefficient of 0.6006 Coke/(m** seconds degrees)) initial conditions : t = 0 to 100 degree water boundary conditions : 1. upper and lower walls are free cooling, the third boundary conditions, maintain the temperature around 20 degrees (H = k/h, h for 1) 2. Beibi insulation, the second boundary condition)
- 2007-04-11 00:14:47下载
- 积分：1
-
Analytical-Gradient-Based-Optimization-Technique
应用共轭梯度法综合优化交叉耦合滤波器。参考文献<Synthesis of Cross-coupled’Resonator Filters Using an Analytical Gradient-Based Optimization Technique >Smain Amari(Synthesis of Cross-coupled’Resonator Filters Using an Analytical Gradient-Based Optimization Technique _Smain Amari-)
- 2010-07-30 11:47:51下载
- 积分：1
-
SpreadSpectrum1
本人亲手做的一个matlab扩频通信系统simulink仿真系统。从发送端到接收到，每部分都相应得加了示波器或频谱仪，可以对照理论清楚观察到信号发生的变化。matlab6.5及以上版本上运行。(I personally make a matlab Spread Spectrum Communication System simulink simulation system. Send-ended to receive from every part of a corresponding increase in the oscilloscope or spectrum analyzer can be clearly observed in the control theory of signal changes. matlab6.5 and above to run.)
- 2021-04-16 13:38:53下载
- 积分：1
-
fastica
学习盲源分离的独立分量分离，可以作为学习盲源分离的基本程序(Learning blind source separation independent component can be used as learning the basic procedures for blind source separation)
- 2010-12-15 16:19:35下载
- 积分：1
-
GM_PHD1
基于高斯线性的概率密度函数滤波估计，以此为蓝本有很多改进或类似的算法，比如CDKF-PHD等(Based on Gaussian probability density function of the linear filter estimation, there are a lot of improvements as a blueprint or similar algorithms, such CDKF-PHD, etc.)
- 2014-11-18 20:37:44下载
- 积分：1
-
QDPSK_2
QDPSK方面的仿真，可以供大家学习参考，还不错，可以看看，仅供参考(QDPSK aspects of simulation, everyone can learn reference, well, you can see, for reference purposes only)
- 2015-04-11 17:34:49下载
- 积分：1
-
PCM_TDM
It simulates the 2 codes both PCM and TDM, taking 3 voice signals as inputs and a multiplexing signal of them as an output graphic
- 2011-05-30 14:38:06下载
- 积分：1
-
matlabfile
many matlab code with Fftseq ,uniform to gauss
AM DSB FM modulation
- 2009-12-20 14:06:57下载
- 积分：1
-
matlab1
说明： 我们知道，小波变换的一级分解过程是，原始信号分别进行低通、高通滤波，再分别进行二元下抽样，就得到低频、高频（也称为平均、细节）两部分系数；而多级分解则是对上一级分解得到的低频系数再进行小波分解，是一个递归过程。以下是一维小波分解的程序.
(We know that a wavelet transform decomposition process is that the original signal were low-pass, high pass filter, and then carried out under the binary sample, we obtained low-frequency, high-frequency (also known as the average, details) coefficient of two parts and Multi-level decomposition is a decomposition of the previous low-frequency coefficients to be further wavelet decomposition is a recursive process. Following is a one-dimensional wavelet decomposition process.)
- 2008-09-29 09:06:45下载
- 积分：1
-
HYSTERESIS
This is a MATLAB Simulation file in which Hysteresis modulation method for a Full Bridge (2-legs) inverter has been done.The load is single Phase R_L.
- 2011-05-11 22:24:53下载
- 积分：1
