-
Kalman_sd
卡尔曼滤波器相关的程序，对目标的速度均方根误差等进行了仿真(Kalman filter procedure, the speed of the target such as root mean square error simulation)
- 2012-08-02 21:18:13下载
- 积分：1
-
311
It is about an communication lab experiment of modulated signals
- 2009-12-20 23:31:50下载
- 积分：1
-
tdm_fir_matlab
Time domain FIR filter!
- 2008-08-19 19:13:54下载
- 积分：1
-
MicrogridSinglePhaseForum
单相微电网的matlab仿真模型，适合初学者(Matlab simulation model of single phase microgrid)
- 2017-10-14 17:08:36下载
- 积分：1
-
fouyen
内含心电信号数据及运用MATLAB写的源代码，是国外的成品模型，小波包分析提取振动信号中的特征频率。( ECG data and includes source code written in MATLAB, Foreign model is finished, Wavelet packet analysis to extract vibration signal characteristic frequency.)
- 2016-08-17 19:49:04下载
- 积分：1
-
双环控制 PV cp1u SPWM
说明： 双环控制，直流母线电压外环，电感电流内环预测控制，3kW光伏并网系统，无升压电路，增量电导法，逆变桥控制最大功率追踪，亲测可用。(DC bus voltage outer loop, inductance current inner loop, 3KW photovoltaic grid connected system, no boost circuit, incremental conductance method, inverter bridge control maximum power tracking, available for pro test.)
- 2020-05-05 18:51:02下载
- 积分：1
-
Radarsys
雷达系统分析和设计的 matlab 版本，适合初学者学习(Radar systems analysis and design of the matlab version, suitable for beginners to learn)
- 2010-06-20 12:04:49下载
- 积分：1
-
alaa_approach-1
matlab file book for stegonography
- 2010-10-11 17:44:44下载
- 积分：1
-
c
说明： simulink 仿真pid控制器 simulink pid controller which is simple to use(simulink pid controller which is simple to use)
- 2010-04-25 23:50:56下载
- 积分：1
-
three_dim_plot
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:56:06下载
- 积分：1
