登录
首页 » matlab » mPRIt

mPRIt

于 2011-10-10 发布 文件大小:1KB
0 157
下载积分: 1 下载次数: 130

代码说明:

   根据雷达信号到达时间用PRI方法进行雷达信号分选的一段matlab代码(Radar signal processing)

文件列表:

mPRIt.m,2704,2011-05-02

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 08
    说明:  数学实验matlab的好程序,给matlab的初学者(Good mathematical experiment matlab program to matlab for beginners)
    2011-03-20 19:47:55下载
    积分:1
  • trans_innerfault
    基于Matlab/Simulink建立的变压器内部仿真模型,可以进行变压器内部整个绕组的单相接地、两相短路、两相接地短路、三相短路等故障的仿真。(The internal simulation model of transformer based on Matlab/Simulink can carry out the simulation of single phase grounding, two phase short circuit, two-phase short circuit and three-phase short circuit of the whole winding. )
    2016-05-02 16:27:25下载
    积分:1
  • stbc7
    空时分组码源代码,对做项目和有课题的学者很有帮助(Space-time block codes the source code, to do projects and academic topics helpful)
    2009-11-09 19:01:27下载
    积分:1
  • sri47
    simulink for two level inverter using svpwm
    2009-06-01 10:12:34下载
    积分:1
  • modulation-techniques
    modulation techniques in communication
    2011-07-20 13:17:16下载
    积分:1
  • dianliujiance
    在matlab仿真环境下利用多次求平均值的方法对无刷直流电机的母线电压和母线电流进行检测,并实现过流保护(Use of multiple averaging method in matlab simulation environment for bus voltage and bus current brushless DC motor is detected, and overcurrent protection)
    2015-01-26 21:33:34下载
    积分:1
  • MLR
    MATLAB的MLR算法,希望对同学的学习有帮助(mlr MATLAB algorithm, very useful, I hope to learn some help)
    2021-04-21 14:48:49下载
    积分:1
  • Simulink-modeling-for-memristor
    研究了惠普忆阻器的电荷控制和磁通量控制模型构建了忆阻器的simulingk模型给出了相应的仿真结果.设计了一种基于matlab的图形用户界面能直观地展示忆阻器特性.通过该界面可以选择或设定输入电压的类型参数及忆阻器模型的参数简单方便地观察对应的输出结果(Studied the HP memristor charge control and flux control model constructed memristor simulingk model gives the corresponding simulation results. Designed a graphical user interface based on matlab can visually show memristor properties. The interface can be selected via the parameter or parameters to set the type of the input voltage and the memristor model is easy to observe the corresponding output)
    2021-04-20 21:18:50下载
    积分:1
  • Crosstalk_f
    该程序用于计算n根平行导线间的串扰,程序结构及说明见程序内。源可以是单频的或脉冲的(这里给出的是频域的)。频率、波形、线长、电源及负载阻抗均可在用MATLAB编写的语句中方便地修改。但必须输入导线系统每单位长度的电感、电容矩阵。(The procedure used to calculate n root of crosstalk between parallel wires, program structure and description of process. Source can be single frequency or pulse (here is given by the frequency domain). Frequency, waveform, the line is long, power and load impedance can be found in the use of MATLAB statements prepared easily modified. However, the system must enter a wire per unit length inductance, capacitance matrix.)
    2008-03-13 17:17:45下载
    积分:1
  • HHT
    希尔伯特黄变换的源代码及其MATLAB软件包(HHT code)
    2010-12-20 10:24:51下载
    积分:1
  • 696518资源总数
  • 104269会员总数
  • 42今日下载