-
GenericAlgorithmPID
应用MATILAB编程实现了遗传算法整定PID控制器参数，并应用于一阶延迟模型的控制，并进行了阶跃响应仿真。(Application Programming MATILAB a genetic algorithm-tuning PID controller parameters, and applies to first-order delay model of control, and a step response simulation.)
- 2007-12-19 21:10:41下载
- 积分：1
-
smithch
本函数在matlab实现阻抗圆图，通过调用switch（）函数，可以得出传输线的反射系数，以及支节匹配等参数，本函数可以实现单、双和三支节匹配。(The realization of the impedance function in matlab circle map, by calling the switch () function of transmission line can be drawn of the reflection coefficient, as well as the support section to match the parameters, this function can achieve a single, double and three matching section.)
- 2009-04-22 20:26:20下载
- 积分：1
-
example8_1
bp算法基于matelab 环境下的 算法(bp algorithm matelab environment based on the algorithm)
- 2009-07-17 09:52:22下载
- 积分：1
-
Video-huong-dan-doc-tutorial-trong-opnet11.5
introduce install omnet by video
- 2010-05-28 09:13:55下载
- 积分：1
-
MLP_BP_Matlab_V1
Implementation of two layer multiperceptron neural networks
- 2014-02-03 14:12:39下载
- 积分：1
-
otsu
OTSU Gray-level image segmentation using Otsu s method.
Iseg = OTSU(I,n) computes a segmented image (Iseg) containing n classes
by means of Otsu s n-thresholding method (Otsu N, A Threshold Selection
Method from Gray-Level Histograms, IEEE Trans. Syst. Man Cybern.
9:62-66 1979). Thresholds are computed to maximize a separability
criterion of the resultant classes in gray levels.
OTSU(I) is equivalent to OTSU(I,2). By default, n=2 and the
corresponding Iseg is therefore a binary image. The pixel values for
Iseg are [0 1] if n=2, [0 0.5 1] if n=3, [0 0.333 0.666 1] if n=4, ...
[Iseg,sep] = OTSU(I,n) returns the value (sep) of the separability
criterion within the range [0 1]. Zero is obtained only with images
having less than n gray level, whereas one (optimal value) is obtained
only with n-valued images.
- 2009-03-17 17:57:51下载
- 积分：1
-
cdma
找到的编写的CDMA通信系统的仿真程序，发上来分享一下，同时附带具体的程序说明文档。(Found in the preparation of the CDMA communication system simulation program, a table to share, at the same time attached to the specific procedure documentation.)
- 2008-06-09 20:51:35下载
- 积分：1
-
boshuxingcheng
对于N=11的标准线阵，分别采用如下波束形成器进行最优波束形成，要求含有干扰信号和噪声。
1、最小方差无失真响应（MVDR）波束形成器；
2、最小功率无失真响应（MPDR）波束形成器。(Minimum variance distortionless response (MVDR) beamformer
Minimum power distortionless response (the MPDR) beamformer.)
- 2012-05-06 12:37:37下载
- 积分：1
-
mmread
运动目标的检测，可以检测出车辆的移动轨迹(Moving Target Detection)
- 2012-05-23 03:45:56下载
- 积分：1
-
TC
说明： A Turbo code simulation in matlab
- 2011-03-29 14:34:59下载
- 积分：1
