-
step_linear_predetict_and_Weiner_filter
一步线性预测与Weiner滤波的比较，含GUI界面.(Step linear prediction compared with the Weiner filter, with GUI interface.)
- 2010-07-23 22:18:25下载
- 积分：1
-
DNLandINLofAD
用MATLAB仿真AD设计中的DNL和INL计算(AD Design using MATLAB simulation of the DNL and INL calculation)
- 2021-04-06 22:29:02下载
- 积分：1
-
matlab6x
matlab6.x图像处理书籍
仅供参考
MATLAB
图像处理(matlab6.x MATLAB image processing image processing books for reference only)
- 2010-05-08 11:34:25下载
- 积分：1
-
reed-solomon-4.0
This package implements a general purpose Reed-Solomon encoding and decoding
facility.
- 2010-08-12 08:29:01下载
- 积分：1
-
railways
tHIS IS CODED EXAMPLE FOR RAILWAY MANAGEMENT SYSTEM
- 2014-11-20 18:16:58下载
- 积分：1
-
LMS-auto-adapter-fiter
考虑一个线性自适应均衡器的原理方框图如《现代数字信号处理导论》p.275自适应均衡器应用示意图。用LMS算法实现这个自适应均衡器，画出一次实验的误差平方的收敛曲线，给出最后设计滤波器系数。一次实验的训练序列长度为500。进行20次独立实验，画出误差平方的收敛曲线。给出3个步长值的比较。(consider a linear adaptive equalizer block diagram as the principle of "modern digital signal processing" Introduction to the p.275 adaptive equalizer application schema. LMS algorithm with the adaptive equalizer, painted a square experimental error of convergence curve, given final design filter coefficients. Experimental a length of the training sequence to 500. Conduct 20 separate experiments, painted square error of the convergence curve. Given three step-value comparisons.)
- 2006-08-29 08:35:00下载
- 积分：1
-
psolssvm
matlab粒子分析算法工具箱，这是最新的希望对有需要的人有用，这个是源代码(matlab particle analysis algorithm toolbox, which is the latest hope useful for people in need, this is the source code)
- 2013-05-20 19:02:20下载
- 积分：1
-
Auto_Measure_system
利用ccs环境、MATLAB环境、DSP（TMS320F2812)、被测对象和Agilient网络分析仪E5071B，构建一个自动测量系统。
相信大部分人都知道基于NI公司的GPIB总线，可以实现自动测量，但NI公司的方案实在太昂贵，采用MATLAB能够大大降低成本。matlab与ccs之间基于RTDX协议进行数据交换，同时matlab基于TCP/IP协议与E5071B之间通信，源码说明如下：
（1）RTDX_ok目录：matlab7.0代码，包含了一个用GUI实现的界面和相关的具体代码，特别是在其中实现了SCPI语言来对仪器进行控制。
（2）TMS320F2812目录：包含ccs下的c代码，如果没有做过RTDX的应用，相信这个对你很有启发。(Use ccs environment, MATLAB environment, DSP (TMS320F2812), the measured object and Agilient network analyzer E5071B, construct an automatic measurement system. I believe that most people are aware NI' s GPIB-based bus, you can realize automatic measurement, but NI' s program is too expensive, the use of MATLAB can greatly reduce costs. ccs between matlab and RTDX protocol-based data exchange, while matlab based on TCP/IP protocol and communication between the E5071B, the source described as follows: (1) RTDX_ok directory: matlab7.0 code, contains a GUI implementation with the interface and specific code, especially in one of implementation of the SCPI language to control the apparatus. (2) TMS320F2812 directory: contains ccs of c code, if not done RTDX application, then I think it was very instructive for you.)
- 2009-03-27 21:43:54下载
- 积分：1
-
Radarsystemsimulation
matlab codes for ofdm and radars
- 2009-12-11 18:46:10下载
- 积分：1
-
080609
说明： 基于MATLAB的FIR带阻数字滤波器的设计
由于生物医学信号处理过程中易混入50Hz噪声的特点，本文利用程序设计法和FDATool设计法，设
计一带阻滤波器，并将设计的滤波器应用到一混和正弦信号，通过测试检验，该滤波器可以很好地消除50Hz的工
频干扰。(】To prevent the biomedical signals from being disturbed by 50Hz noise easily，the paper designs a
bandstop digital filter by procedure and FDATool method．The filter is tested by a blended 81ne wave experimentally and the
result shows that the filter can cancel the 50Hz noise very well．)
- 2009-08-09 11:04:10下载
- 积分：1
