-
1
说明: Canny Edge Detector Algorithm and Matlab Codes
- 2009-03-13 13:55:46下载
- 积分:1
-
buildgui
Matlab 官方工具箱使用说明
buildgui图形用户界面设计手册.pdf(Official Matlab toolbox for use graphical user interface buildgui Design Manual. Pdf)
- 2008-01-26 17:24:42下载
- 积分:1
-
Gabor
gabor变换的论文,雷达信号处理方面的,很有用!!!(a paper about the gabor transformation of radar signal processing)
- 2010-11-19 19:33:40下载
- 积分:1
-
Hw1_Q1_a
FDTM code for square area
- 2012-06-26 21:01:17下载
- 积分:1
-
Cleves_Corner_Compressed_Sensing
"Magic" Reconstruction: Compressed Sensing.
- 2013-03-23 09:07:05下载
- 积分:1
-
DONGLIXUEMOX3S
基于多相催化反应动力学的特点和基本原理,提出多相催化反应动力学方程的一般形式,并介绍了用Matlab语言设计确定多相催化反应动力学方程参数的通用程序.处理时先对实验测定不同时刻对应的反应速率v0和浓度C(或压力P),利用无约束最优化计算方法求出多相催化反应动力学方程参数.文中以镍硅藻土催化苯加氢合成环己烷的实验数据为例进行验证,结果表明,利用所编程序确定的动力学方程和理论值及文献值很好吻合.(Based on the characteristics and dynamics of the basic principles of heterogeneous catalysis, heterogeneous catalysis proposed general form of kinetic equation and introduces heterogeneous catalytic reaction kinetics equation to determine the parameters used in Matlab language design common procedures when handling the first experimental measured at different times corresponding to the concentration of the reaction rate v0 and C (or pressure P), the use of unconstrained optimization calculations obtained heterogeneous catalytic reaction kinetics equation parameters. text nickel diatomaceous earth catalytic hydrogenation of benzene cyclohexane an example to validate the experimental data, the results show that the equations and theoretical value and dynamics literature values determined using the programmed good match.)
- 2014-01-13 09:22:30下载
- 积分:1
-
matlab_BPSK
用matlab实现的BPSK仿真;分析它的误比特率,并用matlab显示;(BPSK simulation using matlab implementation of its bit error rate, and using matlab display )
- 2010-07-07 21:19:54下载
- 积分:1
-
signal_analyzer
说明: 最近看到有人提问怎样用FFT实现频谱分析,我认为能够进行到频谱分析的人,对于系统研究的深度基本上已经相当不错了。本人今天做了一个例程,发给大家参考一下。
历程主要内容(signal_analyzer.rar)如下:
test1.txt 第一列为时间t,0.001s为步长;第二列为系统的输入信号;第三列为系统的输出信号。
signal_analyzer.m首先将test1.txt 的数据读入workspace,然后进行FFT,分析出两信号的频率,输出对于输入的幅值衰减(db),输出对输入的相位差。(The question was asked recently to see the realization of how to use FFT spectral analysis, I think that spectral analysis can be carried out to those who study the depth of the system basically is already quite good. Today I made a routine, distributed to Members for reference. The main contents of the course (signal_analyzer.rar) are as follows: test1.txt the first time as t, 0.001s for the step the second as the system input signal the third as a system output signal. signal_analyzer.m first test1.txt data read into workspace, and then proceed to FFT, analysis of the two signal frequency, output amplitude for input attenuation (db), the output of the input phase difference.)
- 2008-10-25 10:29:35下载
- 积分:1
-
85375555Tracking
gps信号的跟踪环程序 可以实现最基本的载波环跟踪功能(gps signal tracking loop program can achieve the most basic function of the carrier tracking loop)
- 2010-05-11 16:37:15下载
- 积分:1
-
comgt.0.32
一个有关GMSK基带调制和实现的MATLAB程序,自己编写的,请高手指教!
(on a GMSK baseband modulation and realization of the MATLAB program, the preparation of their own, experts advise.)
- 2007-03-24 19:43:01下载
- 积分:1