-
Carrie-recover
这是一篇外国的硕士论文，针对无线通信载波恢复的，文中有matlab编写的模块（源代码）(This is a foreign master' s thesis for wireless communications carrier recovery, and the text written in matlab module (source code))
- 2011-11-28 17:20:58下载
- 积分：1
-
simulationguangxianzhuiji
光线追击程序，可以对光线的传播行为进行仿真，功能强大，绘图精美，将安装包放在MATLAB子目录下并进行相应设置即可使用。(Raytracing program, you can simulate the propagation of light, powerful, beautiful graphics, the package will be installed on the MATLAB subdirectory and make the appropriate settings to use.)
- 2014-01-07 04:43:57下载
- 积分：1
-
partA
四阵元无噪声干扰理想情况下，智能天线波束赋形(Smart Antenna beam-forming)
- 2011-07-24 11:55:18下载
- 积分：1
-
phase1-optimal
i want to download the codes
- 2014-12-08 02:36:38下载
- 积分：1
-
mica21
利用CC1000通信的仿真程序.这是适用于无线传感器网络Mica2平台的程序.(use CC1000 communication simulation program. This is applicable to the wireless sensor network platform Mica2 procedures.)
- 2006-09-23 21:14:43下载
- 积分：1
-
bluetooth
蓝牙通信系统仿真设计和代码，分为四部分：
信号传输部分，信号接收部分，谱分析显示部分，误码分析部分(Bluetooth communication system simulation design and code, divided into four parts: part of the signal transmission, signal receiving part, spectral analysis shows that part of the error analysis section)
- 2009-12-13 23:04:47下载
- 积分：1
-
suspension
matlab simulink for automotiv suspension system.
- 2012-09-05 13:55:19下载
- 积分：1
-
小波分解 fusion
利用matlab进行小波分解，然后重构得到融合影像，并进行傅里叶分类(The use of matlab wavelet decomposition, and then reconstruct fused image and Fourier classification)
- 2014-03-24 16:06:00下载
- 积分：1
-
dianliuchadong
关于输电线路电流差动保护的编程实现，使用了simulink的方式进行建模分析(Transmission line current differential protection)
- 2014-06-05 08:42:02下载
- 积分：1
-
999
根据有无固定基础设施，无线局域网又可分为BSS (Basic Service Set)和IBSS (Independent Basic Service Set)。我们要研究的ad hoc网络属于后者。假设在一个ad hoc网络中，移动节点的发射功率PTx总是恒定的。要发送数据的移动节点总是先监听信道，测量接收到的信号功率X，其中X= I + N, I为接收到的干扰，N是噪声。移动节点只有在X＜INThre时，才可以发射。式中，INThre为背景噪声门限。
在仿真中，我们规定每个移动节点的发射功率是常数，PTx = 1W；接收节点接收机的灵敏度Smin = -80 dBm；信号质量 min = 2 dB；系统的背景噪声门限INThre = 1.2e-10。
(According to the availability of fixed infrastructure, wireless local area network can be divided into BSS (Basic Service Set) and IBSS (Independent Basic Service Set). We have to study the ad hoc network belong to the latter. Assuming in an ad hoc network, mobile node s transmission power is always constant PTX. To send data to the mobile node always monitor channel, measuring the received signal power X, which X = I+ N, I was received interference, N is the noise. Mobile node only when X <INThre when it is fired. Where, INThre threshold for background noise. In the simulation, we require that each mobile node s transmission power is constant, PTx = 1W receiver node receiver sensitivity Smin =-80 dBm signal quality )
- 2008-01-16 00:23:39下载
- 积分：1
