-
Matlab7
matlab基础与提高，非常好的一门教程(matlab basic and enhance, a very good tutorial)
- 2009-02-25 11:59:45下载
- 积分：1
-
119128669matlab-dsb
很好的matlab 源代码学习资料,很好的matlab 源代码学习资料
- 2009-04-05 13:20:09下载
- 积分：1
-
3DMIMOchannel--3DMIMO
3D-MIMO信道模型 仿真代码 可由此建立LTE现今采用的3DMIMO模型(3D-MIMO channel model simulation code can thus establish 3DMIMO model today adopted LTE)
- 2021-04-13 15:08:56下载
- 积分：1
-
calibr
The camera calibration toolbox for Matlab (version 3.0) utilizes a new bias correction procedure for circular control points and a nonrecursive method for reversing the distortion model
- 2007-11-01 11:17:50下载
- 积分：1
-
ex6
performance improvement with different codes
- 2013-11-14 12:26:06下载
- 积分：1
-
RESEARCH_ON_END-TO-END_HANDOFF
说明： 本文在研究IEEE802.16e协议和SIP协议的基础上，提出了利用
SIP解决IEEE802.16接入网络中端到端切换的新方案。该方案采用跨
层切换的设计思想，联合MAC层和应用层SIP协议，在底层链路切换
的同时，完成应用层会话的修改，加快了切换过程，减少了切换时延，
提高了切换成功率。本文基于NS2仿真平台，完成了相应的仿真平台
搭建过程，实现了SIP协议模块和WiMAX协议模块的融合，扩展了SIP
协议模块的部分消息，最终在基于SIP协议模块和WiMAX协议的统一
NS2平台上实现了基于WiMAX接入、支持SIP扩展功能的SIP会话建
立和修改过程。
( On the basis of study of WiMfAX and SIP, a new mechanism using
SIP to achieve end-to-end handoff under IEEE802.16e access networks is
Ob
proposed
handoffs,
in this thesis. The mechanism adopts a cross-layer design
which means that the l}iIAC layer handoff procedure can
interleaved with that of the application layer. During the handoff at link
)
- 2010-04-28 09:31:08下载
- 积分：1
-
Projet_NLMS
Matlab NLMS program, ready for using
- 2009-03-29 13:10:28下载
- 积分：1
-
fdlibmex
This code draw a red rectangle aroud the face
- 2009-05-15 03:56:55下载
- 积分：1
-
Gerhana
To calculate gravitation field between moon and earth using charge simulation methods
- 2013-12-24 09:27:17下载
- 积分：1
-
stop-and-wait-arq
Stop-and-wait ARQ is a method used in telecommunications to send information between two connected devices. It ensures that information is not lost due to dropped packets and that packets are received in the correct order. It is the simplest kind of automatic repeat-request (ARQ) method. A stop-and-wait ARQ sender sends one frame at a time it is a special case of the general sliding window protocol with both transmit and receive window sizes equal to 1. After sending each frame, the sender doesn t send any further frames until it receives an acknowledgement (ACK) signal. After receiving a good frame, the receiver sends an ACK. If the ACK does not reach the sender before a certain time, known as the timeout, the sender sends the same frame again.
- 2011-08-03 16:53:31下载
- 积分：1
|
联系客服（QQ：3324461878）
