-
SIFT(lowe)
说明： lower的原版关于sift算法的资料，很难找的哦。本文非常详细的介绍了sift算法，并与常用的边缘检测算法作了比较，是学习sift算法的好资料。(lower of the original information on the sift algorithm, it is difficult to find, oh. This very detailed introduction to the sift algorithm, and with commonly used edge detection algorithms are compared, is the learning algorithms sift the good information.)
- 2010-04-14 14:58:19下载
- 积分：1
-
zi
说明： 在本系统中，信息序列在先经过FSK调制，经过截止频率为25kHz的低通滤波器后（把信号频率限制在25kHz），再进入混频器搬移到更高的频率发送出去，在接收端，用与发送端同步的跳频信号对其进行变频（跳频的解跳处理在此进行），取下边频，然后进行FSK的解调(In this system, the message sequence prior through FSK modulation, through the cut-off frequency of 25kHz after low-pass filter (to limit the frequency 25kHz), and then move into the mixer to a higher frequency to send out, at the receiving end used with frequency hopping synchronization signal transmitter carried on their conversion (FH' s solution to deal with this for jumping), take down side frequencies, then the demodulation of FSK)
- 2010-05-10 20:42:27下载
- 积分：1
-
Serial_communication_in_Matlab
Matlab环境下PC与单片机的串行通信及数据处理(Matlab environment PC and MCU serial communications and data processing)
- 2008-04-23 15:28:17下载
- 积分：1
-
Euler
计算方法中关于改进的Euler方法的Matlab程序，以及实例验证。(Matlab program calculation method, improved Euler method, as well as instances of verification.)
- 2012-10-11 18:14:04下载
- 积分：1
-
bandwidth
计算输入信号的功率谱密度和估计输入信号带宽并绘图(Evaluation of the single-sided ESD and frequency bandwidth)
- 2009-06-19 09:05:42下载
- 积分：1
-
Microstrip-band-elimination-filter
本代码应用FDTD 方法模拟微带带阻滤波器，并得到S11，S12 曲线以及显示电磁波在空间的传播。频率范围为0-20GHz。微带基片的相对介电常数为6.15，厚度是1.27mm。(Application of FDTD method to simulate the code microstrip band-stop filter, and get S11, S12, and the curve shows the spread of electromagnetic waves in space. Frequency range of 0-20GHz. Microstrip substrate relative dielectric constant of 6.15, the thickness is 1.27mm. )
- 2020-11-13 22:19:42下载
- 积分：1
-
readyuv
convert frames to yuv files
- 2009-07-08 19:04:14下载
- 积分：1
-
rama
PERFORMANCE EVALUATION OF THREEPHASE
INDUCTION MOTOR DRIVE FED FROM
Z-SOURCE INVERTER
- 2011-11-26 18:59:43下载
- 积分：1
-
spectral_clustering_cogs118b-master
1. 按照式计算相似性矩阵
2. 排除自身的相似度
3. 按照式计算归一化矩阵
4. 按照式计算归一化拉普拉斯图矩阵L
5. 计算L的特征向量，将前个特征值最大的向量按列放置成一个矩阵，即依次为前个特征值最大的特征向量
6. 归一化X形成矩阵Y
7. 对矩阵Y按每行为一个数据点，进行k-means聚类，第行所属的类就是原来所属的类。(1. similarity matrix based on formula computation
2. rule out your own similarity.
3. normalized matrix based on formula computation
4. normalized formula Laplasse matrix L according to formula.
5. Calculate the eigenvectors of L. Place the vectors with the largest eigenvalues in columns into a matrix, that is, the eigenvectors with the largest eigenvalues in turn.
6. normalized X formation matrix Y
7. K-means clustering is applied to matrix Y according to one data point per behavior. The first row belongs to the original class.)
- 2018-11-16 09:14:48下载
- 积分：1
-
BPSK
对BPSK的调制与解调进行了详细的MATLAB仿真，详细，简单，易懂(BPSK modulation and demodulation of a detailed MATLAB simulation, detailed, simple, understandable)
- 2010-10-31 16:30:17下载
- 积分：1
