登录
首页 » PDF » 3L-npc-v-source-inverter

3L-npc-v-source-inverter

于 2012-06-10 发布 文件大小:495KB
0 101
下载积分: 1 下载次数: 53

代码说明:

  an active power filter implemented with inverter

文件列表:

a three-level npc voltage-source inverter.pdf,539842,2012-06-02

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • 0089fenfshan
    智能风扇pwm控制电机转速调速系统毕业设计资料(Intelligent fan pwm control motor speed governor system graduated design information)
    2012-11-13 10:40:41下载
    积分:1
  • ansys-input-adams1
    ansys导入到adams中做刚柔耦合动力学分析,采用的是梁单元,希望对大家做刚柔耦合动力学分析有所帮助(ansys and adams are work together)
    2013-12-22 15:22:10下载
    积分:1
  • 51-IO-port-uart--C
    单片机模拟UART,实现软件模拟串口,C语言编写(Single-chip analog UART, software simulation serial, C language)
    2013-08-09 20:10:21下载
    积分:1
  • SI24R1_TEST
    自己编写的SI2401通信测试程序。(其中有以下三种模式:ACK通信、NOACK通信、ACK通信-跳频)( U81EA u5DF1 u7F16 u1991 u7181 u901A u901A u4FE1 u6D4B u8BD5 u7A0B u5E8F u3002 uFF08 u5176 u4E2D u6709 u4E0B u4E09 u79CD u6A21 u5F0F uFF1AACK u901A u4FE1 U3001NOACK u901A u4FE1 u3001ACK u901A u4FE1- u8DF3 u9891 uFF09)
    2021-03-02 08:19:34下载
    积分:1
  • stm32F105CAN
    MDK环境下实现STM32F105,双CAN中继的功能。(MDK environment the STM32F105, CAN relay function.)
    2013-05-14 15:25:01下载
    积分:1
  • CPLD
    控制三相步进电机及光电编码器的采集,当电机停止时,保证三相里面只有一相相通,防止停止时电流过大.(Control three-phase stepper motor and optical encoder collection, when the motor stops to ensure that only one phase of three-phase inside the heart, and to prevent too much current is stopped.)
    2008-05-26 11:37:38下载
    积分:1
  • 08. CAN_TX_RX_PA11_12_125K_UART2_042F6
    STM32F042F6 TSSOP20封装实现CAN收发、UART2通信(STM32F042F6 TSSOP20 package realizes CAN transceiver and UART2 communication.)
    2018-05-22 10:26:17下载
    积分:1
  • 2.程序
    说明:  在此基础上,设计一种温度测量系统,能够检测温度,并通过按键调整温度的上下限值,若超过该限值,进行报警提示。该系统的硬件子电路主要用Protues仿真软件实现,具体的子电路包括:恒流源电路(TLC2543芯片)、信号放大调理电路(两线制铂电阻PT100)、单片机最小系统(AT89C51)、A/D转换电路、按键电路、显示电路、声光报警器等。该系统的软件电路以C语言为基础,在Keil中实现。最后通过软硬结合,实现电路的各种情况仿真,以此验证电路设计的正确性和合理性。(On this basis, a temperature measurement system is designed, which can detect the temperature and adjust the upper and lower limits of the temperature by pressing the key. If it exceeds the limit, an alarm will be given. The hardware sub circuit of the system is mainly realized by Proteus simulation software. The specific sub circuits include: constant current source circuit (TLC2543 chip), signal amplification and conditioning circuit (two-wire platinum resistance PT100), minimum system of single chip microcomputer (AT89C51), a / D conversion circuit, key circuit, display circuit, sound and light alarm, etc. The software circuit of the system is based on C language and implemented in keil. Finally, through the combination of hardware and software, the circuit simulation is realized to verify the correctness and rationality of the circuit design.)
    2021-01-20 10:36:29下载
    积分:1
  • lsm6ds3
    lsm6Ds3的硬件IIC驱动程序,读取角速度及加速度,设置LSM中断。(The hardware IIC driver of lsm6Ds3 reads the angular velocity and acceleration and sets the LSM interrupt.)
    2020-07-10 17:08:55下载
    积分:1
  • Rec_PWM
    基于PSCAD软件环境,利用PWM调制方法实现整流器的仿真(Based on PSCAD software environment based on the simulaiton of rectifier using PWM modulation method。)
    2010-05-07 11:49:20下载
    积分:1
  • 696518资源总数
  • 104349会员总数
  • 32今日下载