-
FrequencyEstimation
单音信号的一些频率估计程序，最大似然方法,Pisarenko法等。(This site presents some Matlab (tm) code for estimation of the frequency of a single, constant tone in noise. While these methods may be extended to the multiharmonic and multi-tone cases, these programs do not include this extension. )
- 2009-12-19 13:19:48下载
- 积分：1
-
fx_cs
buck电路的matlab仿真，单环控制(matlab simulink of buck circuit)
- 2012-05-01 13:48:46下载
- 积分：1
-
POINT-OF-COLLAPSE-AND-CONTINUATION-METHODS-FOR-LA
electrical engineering
- 2013-05-08 02:43:42下载
- 积分：1
-
reweighted_least_squares
an algorithm for solving the "hot" compressed sensing problem. The file includes the matlab programme and a pdf document of the principle of the algorithm
- 2009-09-28 19:23:23下载
- 积分：1
-
2nd
試做錄音.讀音訊檔
並做FFT轉換和端點偵測(介面)
MATLAB程序(Try to do the recording. Reading audio files and do the the FFT conversion and endpoint detection (interface) MATLAB program)
- 2012-09-23 21:59:09下载
- 积分：1
-
zaoshe
Matlab 降噪程序，使用LMS算法去除噪声，在一段添加噪音的音频文件中滤除噪声！(Matlab Noise reduction LMS)
- 2015-03-19 10:26:29下载
- 积分：1
-
DG-solver
Discontinuous Galerkin finite element code for Hyperbolic (Euler) equation solver in C
- 2014-09-23 03:07:18下载
- 积分：1
-
Matlab-HW1
信号与系统matlab作业，实现卷积操作，供学习信号与系统的同学们参考(1. Define two signals as:
x1[n] =
n, 0 < n N1+1
2
N1 − n+ 1, N1+1
2 < n N1
0, elsewhere
and
x2[n] = 1, 0 < n N2
0, elsewhere
We let N1 = 999 and N2 = 500.
(a) (30 )Write a MATLAB function myconv to compute x1[n]x2[n] where
denotes the convolution sum. You have to plot your result and attach
it in your report. You may use the MATLAB function conv to check
whether your result is correct.)
- 2014-10-29 22:19:56下载
- 积分：1
-
dc
说明： 直流电机启动模型，自己做的，可以交流作业用(dc start)
- 2015-01-09 11:26:30下载
- 积分：1
-
INVERTERPWMcompensater
compensation of dead time effect of the inverter dead time effect causes the impact of the control performance of the INVERTER system, and pointed out that the dead time compensation, the key lies in the current phase of the acquisition, in order to overcome the practical zero of the current ambiguity of the system is proposed based on the two-phase stationary coordinate system under the feedforward dead-time compensation method. by the offset voltage of the three-phase output current cycle Fourier transform is found only compensation 1, 5, 7 harmonic components to eliminate the dead time effect. simulation and experimental results verify the correctness and feasibility of this approach.
- 2013-11-11 23:14:37下载
- 积分：1
