-
mocomp3---Copy
motion compensation in sar simulation
- 2012-07-03 12:48:12下载
- 积分：1
-
Clamping-Bridge-Inverter
This code contains a modeling of a clamping bridge for the stabilizing of the inverter s Inputs Voltage
- 2012-11-16 14:15:45下载
- 积分：1
-
matlab
对于线性代数等知识在matlab的编码。主要有讲解ppt和matlab代码。(For linear algebra knowledge encoded in the matlab. Mainly explain ppt and matlab code.)
- 2014-11-21 04:36:57下载
- 积分：1
-
bearings1
bearing faults detection
- 2012-09-16 01:18:07下载
- 积分：1
-
untitled001
直流恒负载转速调节，转速环突然断路matlab(DC Constant load speed regulation, speed loop circuit suddenly matlab)
- 2010-07-11 22:33:44下载
- 积分：1
-
fz
说明： 自己写的一个fastica程序，分离结果还可以，可用(Write a fastica own procedures, the separation results can also be used)
- 2009-05-28 14:44:44下载
- 积分：1
-
Good-PPT---Image-Registration.pdf.tar
Important PPT in compressed form and useful for researcher
- 2014-10-16 22:29:46下载
- 积分：1
-
7654356
右边伸出的bar导航，IOS编程学习源码，很好的参考资料。(Bar navigation right out, learning IOS programming source code, a good reference.)
- 2013-12-05 09:38:30下载
- 积分：1
-
base
1.分别在两个图中画出δ(n)和δ(n-2)，其中-10≤n≤10，画出U（n）其中-10≤n≤10。
2.分别在两个图中画出x1(n)=cos(2π×20×0.01×n)，0≤n≤10和x2(n)=(0.8)n，1≤n≤6。
3.由上一题，计算y(n)=x1(n)+x2(n)，并画图。(1. Draw the figure at two δ (n) and δ (n-2), where-10 ≤ n ≤ 10, draw the U (n) where-10 ≤ n ≤ 10. 2. Respectively in the two Draw the figure x1 (n) = cos (2π × 20 × 0.01 × n), 0 ≤ n ≤ 10 and x2 (n) = (0.8) n, 1 ≤ n ≤ 6. 3. from the previous question, calculate y (n) = x1 (n)+ x2 (n), and drawing.)
- 2010-11-26 16:34:06下载
- 积分：1
-
ZZLfmdetc
在瑞丽噪声背景下，对chirpt信号进行检测的仿真程序(signal detection of LFM)
- 2010-05-18 01:04:59下载
- 积分：1
