-
jadeR
独立分量分析的程序,MATLAB环境下编写的,采用的是JADE方法,可用来进行盲源分离(Independent component analysis program, MATLAB environment prepared by the JADE method can be used for blind source separation)
- 2010-09-25 15:02:19下载
- 积分:1
-
Matlab_yiqun
MATLAB蚁群算法源程序,和大家一起分享!和大家一起多多交流学习!(MATLAB source code ant colony algorithm, and to share with everyone! Learn more exchanges with everyone!)
- 2010-05-19 20:28:04下载
- 积分:1
-
Diagrama_Array4_Tonpilz
Modified version - Plots the irradiation diagram of a quad-element Tonpilz array
- 2014-12-02 07:11:43下载
- 积分:1
-
awgn--cdma
cdma系统的在信道条件下的仿真,可以参考系统仿真是如何运行的。(cdma simulation using ds)
- 2014-11-06 20:34:16下载
- 积分:1
-
12093206LPCC
matlab lpcc file content
- 2011-01-01 14:00:10下载
- 积分:1
-
123426
注水算法是根据某种准则,并根据信道状况对发送功率进行自适应分配,通常是信道状况好的时刻,多分配功率,信道差的时候,少分配功率,从而最大化传输速率。本文运用matlab通过对注水算法在mino系统中的三种不同的情况下进行了仿真,比较出在小信噪比时,相同信噪比下利用CSI的功率注水算法获得容量优于未知CSI的平均功率分配算法;相同容量下已知CSI信噪比比未知CSI时的信噪比小3dB.当信噪比增大到一定程度时,功率注水算法所获得的信道容量将收敛到平均功率分配的信道容量。(Water flooding algorithm is based on certain standards, and according to the channel condition to adaptive allocation of sending power, usually is a good moment, channel situation more distribution power, channel is poor, less power distribution, so as to maximize the transmission rate. This paper USES matlab based on water flooding algorithm in Austin system of three different cases are simulated and compared in small SNR, under the same SNR use CSI power allocation algorithm for capacity is superior to the average power allocation algorithm of unknown CSI Same capacity known CSI signal-to-noise ratio than the unknown CSI small signal-to-noise ratio of 3 db. When the signal-to-noise ratio increases to a certain degree, the power allocation algorithm for channel capacity will converge to the average power distribution channel capacity.
)
- 2013-09-03 20:28:15下载
- 积分:1
-
german_highway-master
高速公路上关于车流量与速度关系,以及发生事故的可能性。(About the relationship between traffic volume and speed on the highway, and the possibility of accidents.)
- 2014-08-01 17:59:26下载
- 积分:1
-
convolve2
This is not my work but a function I use often. It is much faster than the conv2 function in matlab
- 2009-03-31 10:19:08下载
- 积分:1
-
timeanalysis
说明: 用于结构在动力荷载作用下的时程分析,地震荷载,随即荷载均可,采用newmark方法。(time-domain analysis of a linear strucutre under dynamnic loads。 Newmark method is used.)
- 2020-10-21 20:37:23下载
- 积分:1
-
一种自适应算法 local-mean-decomposition
2005年J.S.Smith提出的局域均值分解LMD(Local mean decomposition)的原始文献,该方法可用于故障诊断、特征提取、振动信号分析等多领域,是较EMD更为温和的一种自适应算法,目前是热门研究方法。(This is the original article about LMD——Local mean decompositon. Ihis method is a novel adaptive decomposition. It is more better than EMD and achieve more and more attention.)
- 2012-03-22 18:25:26下载
- 积分:1