-
README-dllset
README dllset是一个很容易确实的系统文件他的作用是更好的利用互联网来检索更多资源并优化(README dllset is an easy to do system files his role is to retrieve more resources and optimize the use of the Internet to better)
- 2013-09-28 17:20:38下载
- 积分：1
-
lungui
轨道车轮踏面接触椭圆参数计算，最终获得椭圆面的长轴与短轴长度(Wheel tread contact with the track ellipse parameters calculated)
- 2011-10-30 21:41:08下载
- 积分：1
-
@fotf
this is a function that represents Black hole optimization algorithm. with these files there are some benchmark problem codes.
- 2013-12-21 13:49:26下载
- 积分：1
-
Chapter_4
Chapter 4 Matlab codes from AEMM book
- 2010-12-09 11:36:16下载
- 积分：1
-
AdaptiveAlgorivvthms
has provided the primary evidence supporting involvement
of the dopaminergic system in the pathology of
RLS. While PET and SPECT imaging of the striatum
held initial promise of linking dopamine abnormalities
to RLS, they have failed to reveal a consistent pattern
of abnormalities. The dopamine-2 receptor binding
potentials of RLS patients have been
- 2010-05-05 17:12:41下载
- 积分：1
-
gauss
用于将经纬度值转换成大地坐标系下的西安80的坐标值(Value for the latitude and longitude coordinates into the earth under the Xi' an 80 coordinate values)
- 2011-09-17 10:41:35下载
- 积分：1
-
upsampex
说明： 上采样和内插，使得系统中同时出现的窄带信号和宽带信号能够采用适合本信号的采样率(On sampling and interpolation, making the system at the same time, the narrowband signals and broadband signals can be used for the signal sampling rate)
- 2008-12-04 09:27:25下载
- 积分：1
-
svpwm_pmsm_kai
说明： 一个开环的SVPWM控制系统，能稳定地控制电机(SVPWM an open loop control system can control the electrical stability)
- 2011-04-06 09:00:37下载
- 积分：1
-
code
刘波——matlab信号处理 18-25章源代码 关于高阶统计量部分 参数模型 线性预测模型 谐波恢复 DOA估计 非线性随机模型 wigner时频分布 时延估计 (Bo- matlab signal processing, Chapter 18-25 source code some parameters on the model of higher order statistics linear prediction model of harmonic restoration DOA estimation of nonlinear stochastic model wigner delay estimation time-frequency distribution)
- 2011-05-06 13:48:37下载
- 积分：1
-
grd_test
xwch_test.m是主测试文件；biaoji.mat存放滤波器系数；xiangweicha.m用FFT计算相位差。
仿真框架为：
1.标记信号和双音信号续接作为发送信号；
2.对双音中一个频率分量的相位做偏移，再经过一个低通滤波器（引入线性相位，模拟收发不能同步测量现象）后，作为收到的信号；
3.用一个检测信号对收发信号进行相关运算；
4.画出收发信号以及相关处理后的信号。找出相关信号的那个尖点，从而推算出收发双音信号0相位点；
5. 输入0相位点位置，计算相对相位差。(xwch_test.m is the main test file biaoji.mat store filter coefficients xiangweicha.m calculated using FFT phase difference. Simulation framework: 1. Mark signals and then as a two-tone signal continued to send signals 2. On a two-tone frequency components of the phase shift to do, and then through a low pass filter (the introduction of linear phase, simulation can not simultaneously send and receive measuring the phenomenon), the as received signal 3. using a detection signal of the transceiver signal correlation operation 4. draw send and receive signals and related processed signal. Correlated signal of the cusp, which calculate the two-tone signal transceiver 0 phase point 5. Enter 0 phase point position, calculate the relative phase difference.)
- 2010-06-12 17:31:00下载
- 积分：1
