-
ptdef5Rfld
Photonic Bands calculation for square lattice photonic structures
- 2009-05-01 19:46:02下载
- 积分：1
-
matlab-simulation
matlab 研究生课件和对应的仿真文件~~~~~(matlab graduate courseware and simulation files ~ ~ ~ ~ ~)
- 2012-06-25 14:15:27下载
- 积分：1
-
noise
噪声的调制，可以改变调制信号频率，观测已经调制波形(Noise modulation can be changed to the modulating signal frequency, the observation has been modulated waveform)
- 2013-04-08 17:03:36下载
- 积分：1
-
RADAR-SIGNAL
八种典型雷达辐射源信号仿真，包括不同参数的信号仿真，可用于信号分选等的雷达信号分析(eight typical radar emitter signals simulation,including the signals with different parameter. this signal can be used for signal deinterleaving)
- 2013-11-27 22:16:40下载
- 积分：1
-
zong
（1） 数据源：随机产生752*8bit作为数据源
（2） 按照DTMB的能量扩散初始相位和生成多项式来产生伪随机数据并对原始数据源进行加扰
（3） 加扰后的数据直接进行解扰，观察误码率的值，验证加扰算法
（4） 按照DTMB标准构造BCH（1023，1013）来实现BCH（762，752）信道编码器和解码器，并观察其误码率是否为0来验证其正确性。
（5） 最后把能量扩散和BCH编码级联，接收端把BCH解码和解扰级联，观察其误码率，验证正确性。
((1) Source: randomly generated 752* 8bit as data source
(2) in accordance with the energy of the initial phase and the diffusion DTMB generator polynomial to generate a pseudo-random data and the original data source scramble
(3) the scrambled data is directly descramble, the bit error rate of the observed values, verification scrambling algorithm
(4) In accordance with DTMB standard configuration BCH (1023,1013) to achieve the BCH (762,752) channel encoder and decoder and observe its error rate is 0 to verify its correctness.
(5) Finally, the energy dispersal and BCH coding cascade, the receiving end of the BCH decoding and descrambling cascade observed error rate, to verify the correctness.)
- 2015-11-18 19:14:05下载
- 积分：1
-
power-flow
网络的三相计算机潮流案例，基于MATLAB 的计算机潮流及其可视化(Three-phase current case computer networks, computer-based trend MATLAB and Visualization)
- 2015-05-29 12:57:53下载
- 积分：1
-
HConvSquar
％ A 2D homogeneous convection-diffusion case (u=exp(-ex*deta*x-ex*deta*y) with a square with
％ all Dirichlet boundary, note that reaction coefficient is not zero
％ by indirect BKM ( A 2D homogeneous convection-diffusion case (u = exp (-ex* deta* x-ex* deta* y) with a square with all Dirichlet boundary, note that reaction coefficient is not zero by indirect BKM)
- 2007-09-24 15:48:01下载
- 积分：1
-
CSI
CSI in a channel no awgn
- 2011-01-02 23:59:56下载
- 积分：1
-
TT
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:46:57下载
- 积分：1
-
matlab_tool
matlab的重要工具箱指导书,相关统计专业的同学和行业内的人都可以学习学习.很好的资料.(matlab toolbox important guide books, statistics, professional students and people in the industry can learn him. good information.)
- 2014-12-14 22:15:02下载
- 积分：1
