-
zui-duan-lu-jing
首先在m脚本文件canshuo.m中输入节点个数和路径权重,在命令窗口中输入canshu,用s=12,e=10的格式输入要求的起止点,再输入main即可得到两点之间的路径和长度。(M script file canshuo.m first enter the node number and the right path lies in the command window enter canshu, with s = 12, e = 10 The format of the input requirements of the start and end points, and then enter the main between two points can be obtained path and length.)
- 2011-06-09 16:00:51下载
- 积分:1
-
tongbudianji
基于Matlab/simulink 同步电机三相短路故障暂态过程仿真分析(Based on Matlab/simulink synchronous motor three phase short circuit fault Transient Simulation Analysis)
- 2014-11-05 20:48:08下载
- 积分:1
-
lms
自适应算法滤波器--lms,以《现代信号处理》(张贤达)书上所讲过程所写(Adaptive algorithm filters- lms, to the "Modern Signal Processing" (Zhang XD) book written by the process of speaking)
- 2013-12-15 14:08:34下载
- 积分:1
-
shearletnew
Demo:演示程序(注意图像路径)
ShearletCoef: 系数计算程序
mybeta: 伪极坐标 Fourier 变换(文件名是暂时的用法)
phi0,psi0,psid: 低高频图像点阵显示(myu,myv用于理论分析,不被 Demo 调用)
psiStock:
FPsi1(2)_x(有编号): shearlet 函数类
bump: 钟形光滑函数
ramp: 斜升光滑函数(即旧版中的 smooth)
新版比旧版提高了框架函数的连续性——对角方向上的生成函数进行了连续化。算法设计上,
伪极坐标 Fourier 变换被独立出来。(Demo: demo program (note the image path) ShearletCoef: coefficient calculation procedure mybeta: pseudo-Polar Fourier transform (the file name is temporary usage) phi0, psi0, psid: low frequency image dot matrix display (myu, myv for theoretical analysis not to be invoked Demo) psiStock: FPsi1 (2) _x (numbered): shearlet function classes bump: bell smooth function ramp: ramp smooth functions (ie legacy of smooth) than the old version of the framework to improve the continuity of functions- diagonal direction of the generating function were continuous. Algorithm design, pseudo-Polar Fourier transform is independent.)
- 2015-03-11 22:42:14下载
- 积分:1
-
IMMKF
利用MATLAB语言计算交互多模型函数IMMKF(Calculated using MATLAB language interacting multiple model function IMMKF)
- 2009-10-06 11:53:32下载
- 积分:1
-
SNDR-test-for-pipelined-ADC
流水线ADC信噪比测试程序,最后一级flash位数可调,可进行SNDR和SFDR的测试(SNDR test for pipelined ADC)
- 2011-06-01 10:40:31下载
- 积分:1
-
exer1
用阵列光电传感器实现空间窄带陷波功能时,采用右图所示的空间权重结构:共有N=2M+1个敏感元件,各敏感元件宽为w,间距为p,中心处敏感元件的权重为+2M,其他2M个敏感元件的权重皆为-1。求此权重函数的傅立叶变换及空间功率谱,并绘图说明当N=7,p=1mm,w=1/3mm时的空间功率谱的零点特征及其应用意义。(With a photoelectric sensor array to achieve narrow-band notch function space, with the weight shown on the right of the space structure: a total of N = 2M+1 a sensitive element, the sensor width w, spacing p, the center of the sensitive components of weight+2 M, 2M a sensitive element of the other weights are all-1. This function find the Fourier transform of the weight and space power spectrum, and the drawing shows that when N = 7, p = 1mm, w = 1/3mm space power spectrum at zero characteristics and application significance.)
- 2011-06-20 20:32:28下载
- 积分:1
-
cosine
cosine similarity measure
- 2010-06-01 02:02:13下载
- 积分:1
-
data-handling-algorithm-learning
数据组合方法研究,该方法是以多项式为基础通过不断筛选组合来辨识非线性系统的模型。该文章详细介绍了该方法的发展及实现步骤。针对该方法中的不足,提出改进措施(Data combination method, the method is based on the polynomial basis through continuous screening combination to identify the model of the nonlinear system. The article describes in detail the development and implementation steps of the method. Deficiencies in the methods, suggest improvements)
- 2013-03-21 15:16:18下载
- 积分:1
-
nginx-source-analyse
nginx源码分析,全面易懂。正在研究nginx的朋友可以看看。(nginx source code analysis, comprehensive and easy to understand.Studying nginx friends can see.)
- 2014-11-13 10:08:35下载
- 积分:1