-
matlab-PLS
很好用，用matlab编的偏最小二乘法，直接在matlab里就可以用。另外带有PLS讲解(Good use, with the partial least squares matlab compiled directly in matlab can be used inside. In addition to explain with PLS)
- 2009-12-23 20:05:02下载
- 积分：1
-
CAPONDOAMATLAB
DOA估计中的延迟相加法，DOA估计经典的传统方法，写学位论文必用，毕设必备(the classic traditional methods, writing a dissertation must be used, complete set essential.
)
- 2011-06-05 17:44:29下载
- 积分：1
-
jiaotongxinhaodeng
主次干道分别亮59s和11s，红灯亮5s，主干道绿灯亮59s，后黄灯5s，同时次干道为红灯亮64s，主干道红灯亮16秒，同时次干道黄灯亮5s后绿灯亮11s。(Liang 59s, respectively, primary and secondary roads and 11s, the red light 5s, green trunk 59s, after the yellow 5s, at the same time at the red light road for 64s, the trunk road red light 16 seconds, while yellow light times 5s roads green after 11s.)
- 2009-05-18 08:53:19下载
- 积分：1
-
matlab
陈仲生 《基于matlab7.0的统计信息处理》(陈仲生" matlab7.0 based on statistical information processing" )
- 2009-06-06 01:13:04下载
- 积分：1
-
omap_hwmod_33xx_data
Hardware modules present on the AM33XX chips.
- 2014-08-09 11:46:09下载
- 积分：1
-
bode
High pass and low pass filters with matlab by using bode plot method. Showing very important thing is that bode plot does not give any information about transient response.
- 2014-02-07 07:35:09下载
- 积分：1
-
DOA-estimation
此文件是DOA算法的Matlab代码，包含了Bartlett算法、Capon最小方差法、Music算法(This file is DOA algorithm Matlab code, including the Bartlett algorithm, Capon minimum variance method, Music algorithm)
- 2013-05-26 11:45:43下载
- 积分：1
-
VMD
变分模态分解的源程序 ，主要用于信号处理(Source program for variational mode decomposition, mainly used for signal processing)
- 2020-11-25 18:49:32下载
- 积分：1
-
WGS84XYZ_2_BJ54XYZ
WGS84到北京54的MATLAB编程的坐标转换(WGS84 to Beijing 54 coordinate transformation of the MATLAB programming)
- 2010-01-17 14:53:16下载
- 积分：1
-
RecPF_v2.2
说明： 基于局部傅里叶变换数据的重构算法的研究,是一种比有效快速的重构算法(New features:
Switched to complex computation, fully compatible with complex data
Replaced penalty parameter continuation by R. Glowinski and P.L. Tallec s alternating direction method (ADM or ADMM)
New parameter/data normalization was added to make parameters rather independent of the image size, pixel intensity range, and number of CS measurements. To find the parameters aTV and aL1 for version 2.0 corresponding to those used in versions 1.1 or 1.0, see Lines 60, 66, and 67 of RecPF.m.
)
- 2020-12-02 21:59:25下载
- 积分：1
