-
Retina
A very good code for identification and classification of retinal vascular
- 2012-12-29 17:02:14下载
- 积分：1
-
CLRC663-DataSheet-Chinese
CLRC663 是高度集成的收发器芯片，用于 13.56 兆赫兹的非接触式通讯。CLRC663 收发器芯片支
持下列操作模式
• 读写模式支持 ISO/IEC 14443A/MIFARE
• 读写模式支持 SO/IEC 14443IB
• JIS X 6319-4 读写模式支持（等效于FeliCa 1 方案，请参阅章节 21.5）
• 相应于 ISO/IEC 18092 的被动发起方模式
• 读写模式支持 ISO/IEC 15693
• 读写模式支持 ICODE EPC UID/EPC OTP
• 读写模式支持 ISO/IEC 18000-3 mode 3/ EPC Class-1 HF
CLRC663 能够透过内建发射器直接驱动外置天线与 ISO/IEC 14443A 或 MIFARE 卡片进行通信，而无
需附加有源电路。数字模块负责全部的 ISO/IEC 14443A 组帧和错误检测功能（奇偶校验和 CRC 循環
冗餘校驗）(The CLRC663 is a highly integrated transceiver IC for contactless communication at
13.56 MHz. This transceiver IC utilizes an outstanding modulation and demodulation
concept completely integrated for different kinds of contactless communication methods
and protocols at 13.56 MHz.
The CLRC663 transceiver ICs support the following operating modes
• read/write mode supporting ISO/IEC 14443A/MIFARE
• read/write mode supporting ISO/IEC 14443B
• read/write mode supporting JIS X 6319-4 (comparable with FeliCa 1 (see
Section 30.5) scheme)
• passive initiator mode according to ISO/IEC 18092
• read/write mode supporting ISO/IEC 15693
• read/write mode supporting ICODE EPC UID/ EPC OTP
• read/write mode supporting ISO/IEC 18000-3 Mode 3
The CLRC663’s internal transmitter is able to drive a reader/writer antenna designed to
communicate with ISO/IEC 14443A/MIFARE cards and transponders without additional
active circuitry. The receiver module )
- 2016-08-18 11:34:28下载
- 积分：1
-
shuxuejianmo_6
说明： （蒙特卡洛方法）
求出四分之一圆占正方形的比例。随机投点P(x,y)于正方形，π/4的近似值为落在四分之一圆内的点数与总投点数的比值。随机投点次数分别为10000次和50000次，计算π的近似值。
((Monte Carlo method) are obtained accounting for a quarter of a round square ratio. Voted random point P (x, y) in the square, π/4 for the fall quarter of the approximation of the points won and the ratio of the total vote points. The number of random points, respectively, voted for the 10000 and 50000 times, the calculation of the approximation of π.)
- 2009-07-24 23:01:33下载
- 积分：1
-
chap5
雷达系统5---------------利用参数进行滤波,并绘制相关图形(Radar system--------------- use parameters to filter and draw relevant graphics)
- 2012-03-21 23:11:59下载
- 积分：1
-
flyback
基于saber仿真软件,是对反激变换器仿真设计的。(Flyback converter design saber-based simulation software)
- 2014-11-28 21:17:42下载
- 积分：1
-
MATLAB-control-Engineering
Control Engineering Programs Using MATLAB
- 2013-04-03 22:42:47下载
- 积分：1
-
beamforming
空间匹配滤波器的输出信号 2D波束方向图 不同扫描方向的波束方向切面图(Spatial matched filter output signal in Fig 2D beam scanning direction different from the direction of the beam section of FIG.)
- 2013-12-31 14:50:31下载
- 积分：1
-
queuingsystem
matlab code of simple queuing system
- 2010-11-21 14:34:09下载
- 积分：1
-
xibo50_37
自己设计的陷波器，matlab实现，可以运行，代码注释清晰，非常适合初学者(Designed notch filter, matlab realize you can run code annotation clear, very suitable for beginners)
- 2012-09-18 16:33:58下载
- 积分：1
-
SoftFocus
Soft Focus using Guassian Blur
- 2014-12-22 10:03:35下载
- 积分：1
