-
RBFlw10
这是matla论文,用来计算RBF输出值很有效(This is matla paper, the output value used to calculate the RBF is very effective)
- 2010-09-13 15:53:00下载
- 积分:1
-
fsk1
基于matlab的2fsk的调制与解调源程序,以及眼图,误码率的计算,相干解调,非相干解调的比较(Matlab-based 2fsk the source of the modulation and demodulation, as well as the eye diagram, bit error rate calculation, coherent demodulation, comparison of non-coherent demodulation)
- 2009-05-02 16:45:31下载
- 积分:1
-
matlab
用matlab分析数值的,有拉个朗日插值、三次样条插值法、NEWTON插值、hermite插值、mewton形式的hermite插值、平方根法、gauss消去法、三角分解法、jacobi迭代法、
gauss迭代法、sor迭代法、最速下降法、共额梯度法、mewton迭代法、逆broyden迭代法。一共15段代码。
(Numerical analysis using matlab, there are a Long Day interpolation, cubic spline interpolation, NEWTON interpolation, hermite interpolation, mewton form hermite interpolation, square root method, gauss elimination, triangular decomposition, jacobi iterative method, gauss iterative method, sor iterative method, steepest descent method, a total amount of gradient method, mewton iterative method, inverse broyden iteration. A total of 15 sections of the code.)
- 2013-11-18 10:04:48下载
- 积分:1
-
29697550Wind_PMSG
永磁直驱风力发电机,并网机侧部分matlab仿真研究(permanent magnel direct drive wind tuibine grid connected inverter side part)
- 2018-06-20 20:29:00下载
- 积分:1
-
DecisionTreeBasedOnHiberarchyDecomposition
传统的决策树能较好地解决分类问题,但当类的个数增多时,所产生的单一决策树就会变得复杂,同时概括能力降低。 该文采用基于层次分解的方法通过产生多层决策树来处理多类问题。 与传统的单一决策树比较, 基于层次分解的决策树在处理多类问题时有许多的优势。(induction learning,decision tree,id3 ,hiberarchy decomposition)
- 2010-06-14 17:26:52下载
- 积分:1
-
BCJL1
bcjr algorithm wihich is ised for decoding convolutional encoder
- 2012-06-04 18:36:35下载
- 积分:1
-
Small-spectral-analysis
说明: matlab程序,小波谱分析mallet算法经典程序,包括1.正弦波定义,2.小波滤波器谱分析,3.MALLET分解算法,4.MALLET重构算法(matlab program, the small spectral analysis algorithm for the classic mallet procedures, including 1. Sine definition, 2. wavelet filter spectrum analysis, 3.MALLET decomposition algorithm, 4.MALLET reconstruction algorithm)
- 2011-02-27 10:05:23下载
- 积分:1
-
MIMO-OFDM-Simulator
多输入多输出正交分频多工模拟器。
正交分频多工:OFDM模拟器(外层函数)
create_channel:产生一个瑞利衰落信道复用,解的天线配置、正交分频多工结构、power-delay档案。
svd_decompose_channel:既然全网络知识是假设,在并行传输奇异值模式。这个函数分解这些频道模式。
BitLoad:适用bit-loading算法来实现预期的钻头和能量
(MIMO OFDM Simulator:
OFDM.m: OFDM Simulator (outer function)
create_channel.m: Generates a Rayleigh fading frequency-selective channel, parametrized by the antenna configuration, the OFDM configuration, and the power-delay profile.
svd_decompose_channel.m: Since full channel knowledge is assumed, transmission is across parallel singular value modes. This function decomposes the channel into these modes.
BitLoad.m: Apply the bit-loading algorithm to achieve the desired bit and energy allocation for the current channel instance.
ComputeSNR.m: Given the subcarrier gains, this simple function generates the SNR values of each channel (each singular value on each tone is a separate channel).
chow_algo.m: Apply Chow s algorithm to generate a particular bit and energy allocation.
EnergyTableInit.m: Given the SNR values, form a table of energy increments for each channel.
campello_algo.m: Apply Campello s algorithm to converge to the optimal bit and energy allocatio)
- 2012-04-30 10:09:02下载
- 积分:1
-
蚁群算法程序(matlab)
基于蚁群算法的物流配送问题:研究如何规划各车辆的路径及任务分配,使得在不违反时间窗的前提下,总走行成本(距离)最少。(Logistics distribution problem)
- 2017-10-23 15:23:10下载
- 积分:1
-
agt_64QAM_download_bit
将数据调制为wifi传输制式的波形,支持BPSK,QPSK,QAM等调制。配置安捷伦E4438C矢量信号发生器,输出带载波的wifi信号(The data transmission system of the modulation waveform for the wifi support BPSK, QPSK, QAM modulation, etc.. Configure the Agilent E4438C vector signal generator, the output signal with a carrier wifi)
- 2013-12-04 00:13:35下载
- 积分:1