-
M-file
信号与系统基础教程 MATLAB例题 (Signals and systems based on MATLAB Tutorial Example)
- 2009-06-08 21:51:39下载
- 积分：1
-
Weighted-average_
数字高程模型（DEM)加权平均算法，计算单个点(Digital elevation model (DEM) weighted average algorithm to calculate a single point)
- 2011-05-30 11:53:27下载
- 积分：1
-
LiuJieBing11
2fsk调制信号在matlab里的仿真框图(The 2fsk modulation signal simulation block diagram in matlab)
- 2013-04-25 22:16:48下载
- 积分：1
-
TEST
三相交流电矢量叠加仿真,自动调平衡补偿，完全始创，难得哦(three phase )
- 2011-04-19 16:19:01下载
- 积分：1
-
shito2m
十进制转化为二进制 m代码 很精简的一个代码，十六位二进制转化都十分迅速(Decimal into binary m code very concise code, very fast 16-bit binary conversion)
- 2012-05-02 16:20:06下载
- 积分：1
-
hough--matlab-tuoyuan
不错的检测椭圆程序 只需要改一些参数即可运行(Good testing procedures only need to change some of the ellipse parameters to run)
- 2011-11-28 10:12:13下载
- 积分：1
-
matlab_antenna_dipole
this codes about design antenna dipole in MIMO.The implementation is based on the earlier
implementations of WINNER II interim model [
- 2013-12-12 18:10:47下载
- 积分：1
-
program
可以将分割完的子图像进行二值化，二值化效果很明显，易于下一步的分割识别(You can split end of the sub-image binarization, thresholding effect is obvious and easy to identify the next stage of segmentation)
- 2010-01-03 10:26:08下载
- 积分：1
-
power_control
四轴动力模块，用一个顶模块控制，输入有：油门（20档）；指令；水平仪控制指令，4个输出口(Axis power modules, with a top module control inputs are: accelerator (20 files) instruction Level control instructions, four output ports)
- 2013-12-26 20:57:03下载
- 积分：1
-
LVRT
不平衡电网条件下，逆变器根据并网准则的要求，需要不脱网运行，并提供无功支撑。本仿真实现了不平衡条件下的逆变器低穿运行，并实现在故障后快速的功率回复(Under unbalanced grid conditions, the inverter according to the guidelines and requirements of the network, you need not run off the network, and provide reactive support. The Simulation of the inverter under unbalanced conditions, low wear operation, and after the failure to quickly realize the power of reply)
- 2015-09-14 20:08:03下载
- 积分：1
