登录
首页 » matlab » CRdectection

CRdectection

于 2010-04-14 发布 文件大小:592KB
0 210
下载积分: 1 下载次数: 0

代码说明:

说明:  :该文首先研究了单认知用户能量检测算法的检测性能和检测灵敏度与检测时长和噪声短时间内平均功率波 动性之间的关系,得出检测性能和检测灵敏度随噪声短时间内平均功率波动性的增大而急剧下降的结论,在低信噪 比时尤为明显;针对检测性能和检测灵敏度随噪声短时间内平均功率波动性的增大而急剧下降,提出了基于多用户 协同能量检测算法。仿真表明,在低信噪比环境下,即使噪声短时间内的平均功率存在较大的波动性,只要适当地 增加协同检测的用户数,仍可获得较为准确的检测性能。(In this paper, detection performance and detection sensitivity with detection duration and noise average power fluctuation in short time is investigated firstly. Performance accuracy and detection sensitivity drop quickly with noise average power fluctuation increasing and it is worse when signal-to-noise ratio lower. Considering the characteristic, a novel new energy detection algorithm based on cooperative is presented. Simulations show that the proposed scheme improves antagonism of noise average power fluctuation in short time and gets a good detection performance as long as increasing the number of cooperative detection users.)

下载说明:请别用迅雷下载,失败请重下,重下不扣分!

发表评论

0 个回复

  • lssvm_regression
    最小二乘支持向量回归模型 直接输入训练集和测试样本即可(Least squares support vector regression model direct input training set and test samples )
    2013-09-25 21:11:25下载
    积分:1
  • New-Compressed-(zipped)-Folder
    code to load, display and play an audio file
    2013-03-22 03:38:53下载
    积分:1
  • matlab
    聚类算法,不是分类算法。分类算法是给一个数据,然后判断这个数据属于已分好的类中的具体哪一类。聚类算法是给一大堆原始数据,然后通过算法将其中具有相似特征的数据聚为一类。这里的k-means聚类,是事先给出原始数据所含的类数,然后将含有相似特征的数据聚为一个类中。所有资料中还是Andrew Ng介绍的明白。首先给出原始数据{x1,x2,...,xn},这些数据没有被标记的。初始化k个随机数据u1,u2,...,uk。这些xn和uk都是向量。根据下面两个公式迭代就能求出最终所有的u,这些u就是最终所有类的中心位置。(Clustering algorithm, not a classification algorithm. Classification algorithm is to give a figure, and then determine the data belonging to a specific class of good which category. Clustering algorithm is to give a lot of raw data, and then through the algorithm which has similar characteristics data together as a class. Here k-means clustering, is given in advance the number of classes contained in the raw data, then the data contain similar characteristics together as a class. All information presented in or Andrew Ng understand. Firstly, raw data {x1, x2, ..., xn}, the data is not labeled. K random initialization data u1, u2, ..., uk. These are the vectors xn and uk. According to the following two formulas can be obtained final iteration all u, u is the ultimate all these classes the center position.)
    2014-02-18 09:59:02下载
    积分:1
  • PWMtrackingcontrol2
    PWM斩波控制电路的matlab/simulink仿真电路,(PWM tracking control PWMmatlab/simulink)
    2020-06-20 20:00:02下载
    积分:1
  • OREILLY-Learning_The_UNIX_Operating_System
    unix operating system
    2007-12-06 08:50:54下载
    积分:1
  • Bubble-Point
    Bubble Point Calculation
    2011-12-01 15:55:19下载
    积分:1
  • svm_mex601
    SVM source code.....................
    2012-02-07 02:13:09下载
    积分:1
  • mreg
    matlab程序中的部分经典算法,仅供参考(matlab program, part of the classical algorithm for reference only)
    2009-09-17 09:17:20下载
    积分:1
  • dimreductionusingpca
    Dimensionality reduction
    2011-05-06 15:11:49下载
    积分:1
  • HYS
    Brushless doubly fed reluctance generator
    2012-07-15 19:20:59下载
    积分:1
  • 696518资源总数
  • 106265会员总数
  • 10今日下载