-
up_down_sample
选择输入信号的参数，以及抽样因子，以及采样参数，对信号分别进行上抽样和下抽样，方便非均匀采样的进行。(Select the input signal parameters, and sampling factors, as well as sampling parameters, respectively, on the signal sampling and down sampling, to facilitate the conduct of non-uniform sampling.)
- 2013-09-16 21:53:21下载
- 积分：1
-
3Visualization
体视化引擎创建了整洁的结构，并给出一个GUI调用的实例。(Volume Visualization Engine to create a neat structure, and give examples of a GUI calls.)
- 2009-03-28 16:43:45下载
- 积分：1
-
zuankongtiaoshi
对周期排布的介质柱上钻有小孔的结果进行平面波的分析(cycle arrangement of the media column of drilling a small hole results plane wave analysis)
- 2007-04-10 18:53:07下载
- 积分：1
-
CCNA2
说明： CCNA中文笔记第2章
DoD模型被认为是OSI参考模型的浓缩品,分为4层,从上到下是1.DoD模型的Process/Application层对应OSI参考模型的最高3层
2.DoD模型的Host-to-Host层对应OSI参考模型的Transport层
3.DoD模型的Internet层对应OSI参考模型的Network层
4.DoD模型的Network Access层对应OSI参考模型的最底2层
(CCNA Chinese Notes Chapter 2 DoD model OSI reference model is considered concentrated products, divided into four layers, from top to bottom is 1.DoD Model Process/Application layer of OSI reference model corresponds to the maximum 3-layer model 2.DoD Host-to-Host layer corresponds to OSI reference model Transport Layer 3.DoD model Internet layer corresponds to OSI reference model Network model Network Access Layer 4.DoD OSI reference model layer corresponds to the bottom layer 2)
- 2010-04-12 10:23:26下载
- 积分：1
-
mfile
ForMATLAB_2011a教程，matlab教程源代码，MATLAB使用和数学知识的丰富层次(ForMATLAB_2011a tutorials, matlab tutorial source code, MATLAB mathematical knowledge to use and rich gradation)
- 2013-07-10 20:00:09下载
- 积分：1
-
paralellfinal
power factor improvement by using converters
- 2015-02-12 23:57:43下载
- 积分：1
-
radar_moving_target_detection
雷达动目标检测，含MTD、MTI、CFAR处理(radar moving target detection)
- 2020-12-04 21:49:23下载
- 积分：1
-
TT
The model used for creating the reference voltage is shown
in Fig. 4. First, photovoltaic output current (Ipv) and output
voltage (Vpv) are passed through a first order low pass filter
with a magnitude of G = 1 and a time constant of T = 0.01
seconds in order to filter out the high frequency components
or harmonics from these signals as shown in Fig. 5 and Fig. 6.
The filtered current and voltage signals (Ipv_F and Vpv_F) are
then fed into the MPPT control block that uses the Incremental
Conductance Tracking Algorithm. An algorithm that is based
on the fact the slope of the PV array power curve shown in
Fig. 7 is zero at the Maximum Power Point (MPP), positive on
the left of the MPP, and negative on the right. The MPP can
thus be tracked by comparing the instantaneous conductance
(I/V) to the incremental conductance (∆ I/∆ V) [11] as in (1):
- 2013-07-23 17:46:57下载
- 积分：1
-
kalman-fil
对坐自由落体的物体的轨迹进行扩展卡尔曼滤波的完整程序(Extensive kalman filter algorithm code for an object doing free falling)
- 2013-03-01 21:00:53下载
- 积分：1
-
main_robust_state
非线性系统的容错鲁棒控制程序代码 超级实用(fault-tolerant control of nonlinear systems)
- 2013-10-04 09:20:20下载
- 积分：1
